That is normal https port, some websites may reference it directly while others skip it, it is fine. You can edit permissions on a per site basis to always ask, block, or allow location access by clicking on the lock icon > Connection (secure/unsecured) > More Information, then change to Permissions tab and set it how you want.

If tired of being prompted about location on all sites you can go into Settings > Privacy & Security, scroll to Permissions, click Settings next to Location, click ‘Block new requests’ and save changes. Per site allow/block/ask can still be configured.

What are max print speed and volumetric set to?

For some filaments (silk PLA) I’ve had to slow things down (120mm/s max print speed and 10mm3/s max volumetric speed) or it comes out horrible. Only used 0.4 nozzles so far though.

On ‘Startup’ section, what options are available for ‘Boot Mode’ ? May want to try using something other than Quick during OS install. Should be able to change it back afterwards for faster boots.

Slicers for FDM are open source and lots of forks. The built-in printer profiles vary a lot but can be created from scratch. You can find lots online to use as examples too. I currently use Cura, Prusaslicer, and Orcaslicer.

I’m more interested in printing plastic than tuning/upgrading the printer itself so I recommend a printer with automatic z-offset and bed leveling. Basic maintenance tasks such as cleaning, oiling, and greasing will need to be done on occasion no matter the printer. Beyond that I’ve only done simple retraction tuning.

I started with Elegoo Neptune 3 Pro. Klipper firmware upgrade improved speeds a lot. It wasn’t bad for a budget printer but lack of automatic z-offset can be frustrating so I replaced & gave it away to friend. Replaced it with Creality K1 which was a lot easier to get started with thanks to automatic z-offset calibration. Output quality is good but to get better would require upgrades + tuning. Been saving up to replace with Bambu Lab P1S combo so I can also do multi-color printing.

Hot Wheels has Marvel series of cars too and took picture of this “well known” one recently.

deleted by creator