We’ve all heard stories of the dangers of 3D printing, with fires from runaway hot ends or dodgy heated build plates being the main hazards. But what about the particulates? Can they actually…
  • john_lemmy@slrpnk.netEnglish
    3·
    24 days ago

    Does anyone here have any tips on low cost ways to vent out these residues from 3D printing?

    • _haha_oh_wow_@sh.itjust.worksOPEnglish
      2·
      23 days ago

      Print with the same setup you’d use with resin printing: It’s an enclosed tent that has filters and venting you can direct outside.

    • jabathekek@sopuli.xyzEnglish
      2·
      18 days ago

      I’ve seen cheap ikea end tables modded for enclosures. Particle board is used to seal up three sides (between each of the legs), and an acrylic panel attached with some cheap hinges goes in the last one to make a door. A hole is cut in one of the boards to allow for ventilation.