Hi there!

I’m looking into getting myself a good printer and I am wondering if I need to install some platform-specific drivers for them to run. I am running Debian 12 (GNU/Linux) and I am afraid that I must run some proprietary blob to connect to the printer.

Could someone share their experience please? Even if you don’t use Linux, your feedback would be very appreciated!

(Also, while you are at it, please share some recommendations for printers, I don’t really know where to go (>v<) Have about ±500€ )

  • quixotic120@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    2 months ago

    In some less common scenarios you may need the ftdi or ch34x drivers. Support for these is usually already in the kernel but if not the ftdi comes with the arduino sdk and the ch34x drivers are available

    You would generally only need this for older or super cheap printers, and even then you would generally only need this if you need to reflash the firmware for some reason or refuse to print from an sd/usb. but don’t refuse to do that, even back in the days before wireless printers it was a dumb idea to print via usb