I have spent parts of the last 2 days trying to finish calibrating a hardened stainless steel .60mm nozzle with Sunlu PLA+ 2.0 filament.
I have been trying to print a test cube and I couldn’t get the first layer to stick period. I washed plates, I swapped plates, I removed the nozzle and reinstalled it.
I swapped different filament brands, and they all printed flawlessly. Try that Sunlu white PLA and instant failure again. I was about ready to admit defeat and dry my first spool of PLA ever because I could think of nothing else to do.
But I took one last look at my settings for this filament. And I finally noticed my flow ratio was set at .096 rather than .96. I didn’t even know the slicer would allow a number that small.
Once again the error was found to be located between the chair and the screen…
Try setting the scarf steps to 1 and the Bridge Flow ratio to 1.5, (as low a 0 and as high as 2). Then under Speed uncheck the Slow Down for Overhangs and set the speed to 20mm/sec. This is often a good place to start and works well on my Bambu mini. For testing, I print an upside down box with a 50x50 cavity and a height of 8mm.